Sumner Machine Works ~ Services |
||
| Spline Axles or Shafts | ... |
$75.00 per Shaft |
| Change Bolt Pattern | Studs not included Parts must be cleaned & bearing removed | $60.00 per Axle or Hub |
| Dana-44 Knuckles Machine top flat& drilled for studs | Studs not included, Knuckles need to be Clean & Ball Joints removed | $45.00 ea. |
| Bore GM 205 | cases for larger bearings customer must clean & empty case | $75.00 |
| Machine Steering Arm Holes | For Hi-Steer or Taper Holes |
$10.00 per hole |
| Convert GM Dana-60 hubs to single wheel hubs. | Studs not included | $225.00 pr. |
| Gears Set up on housing. | Must be clean & empty |
$200.00 |
| Gears Set up on Completed Front End | Includes Disassemble lock-out, hub, spindle, knuckle, center section, axles, clean, re-assemble, pack wheel-bearings, seals, u-joints, bearings or gears
NO PARTS INCLUDED ~ Customer Must Supply Parts |
$650.00 |
| Differential Covers | With Powder Coating
Without Powder Coating |
$200.00 $185.00 |
| Cut & narrow rear semi float rear housing | ... |
$200.00 |
Cut & narrow full-float rear housing |
... |
$250.00 |
| Cut & narrow Dana-60 or Dana-44 front axle | Must be cleaned & disassembled |
$325.00 |
| Cut & turn Dana-44 or Dana-60 front axle | Does not include changing angle of spring pads |
$325.00 |
| Re-drill Rockwell 3rd. member | Center section must be disassembled & clean |
$85.00 |
For more Info Call 620-442-3118 or Email John@sumner-machine.com |
||